# Fielding, Catching and Keeping · Cricket Level 3: Pre-Intermediate

Cricket · Level 3: Pre-Intermediate · Insporta Book (https://book.insporta.app/cricket/level-3/fielding-catching-and-keeping/)

Fielding, Catching and Keeping in Cricket (Level 3: Pre-Intermediate) on Insporta: 50 sourced facts behind 5 tests. Covers: the catching and fielding .

This sub-level teaches how a fielding side is built and run — the named catching and fielding positions and why each one sits where it does, the ring against the deep; slip and close catching, watching the edge, soft hands and the cordon; the outfield, the chase, the pick-up and the throw, backing up, the sliding stop and the boundary catch; wicket-keeping, standing up against standing back, taking spin and the leg-side ball; and run-outs and pressure fielding, the direct hit, which end to throw and squeezing the ring.

## Test 1: The catching and fielding positions

![A cricket field seen from above, the bowler at the top and a right-handed striker at the bottom, so the leg side is the left half of the figure. Fine leg is deep on the boundary behind square, square leg is level with the batter on the ring, midwicket is in front of square, mid-on near the bowler and long-on on the straight boundary. Short leg crouches a couple of metres from the bat, just in front of square.](https://book.insporta.app/diagrams/cricket-fielding-positions-leg-side.svg)
*Leg-side fielding positions for a right-handed batter.*

![A cricket field seen from above, the bowler at the top and a right-handed striker at the bottom, so the off side is the right half of the figure. Behind the bat stand the wicket-keeper and three slips fanning out to the off side, with gully squarer and wider and third man deep on the boundary behind them. Point is square of the wicket, cover in front of square, mid-off near the bowler and long-off on the straight boundary.](https://book.insporta.app/diagrams/cricket-fielding-positions-off-side.svg)
*Off-side fielding positions for a right-handed batter.*

- A ball that just clips the outside edge carries at catching height behind the bat on the off side, so the slips fan out exactly along that line. (Source: ESPNcricinfo coaching glossary)
- A thick or angled edge, especially off a back-foot shot, flies wider and harder than a slip nick, and the gully covers that gap between slip and point. (Source: ESPNcricinfo coaching glossary)
- Ring fielders sit about thirty yards out to cut off the pushed single and the firmly struck shot, keeping the batters to no run or one. (Source: Recognised cricket coaching material)
- A deliberate steer or a streaky edge that beats the cordon rolls away towards the boundary behind point, and third man is there to hold it to one or two. (Source: ESPNcricinfo coaching glossary)
- The biggest straight hits go back over the bowler, so those two deep fielders guard the longest carry and turn a would-be six into two or three. (Source: Recognised cricket coaching material)
- Pushing a catcher or a saver back trades the single, which is now on offer, for cutting off the four, a common move once a batter is set. (Source: ESPNcricinfo)
- Balls worked off the hip or the pads square on the leg side are the bread and butter of a batter's scoring, so square leg cuts off that easy single. (Source: ESPNcricinfo coaching glossary)
- Against a batter yet to get in, the captain backs an early chance, so slips, gully and bat-pad come in and the odd single is left unguarded. (Source: Recognised cricket coaching material)
- Deep square fielders on each side let the batter take a single to them but stop the cut and the pull going for four, keeping the run rate down. (Source: ESPNcricinfo)
- Bat-pad catches pop up softly just off the bat against turn, so those two suicidal close positions only make sense when a spinner is turning it past the edge. (Source: Recognised cricket coaching material)

## Test 2: Slip and close catching

- Picking the ball up as it comes off the bat, rather than tracking it all the way, gives the slip the quickest possible read on a fast, deflected chance. (Source: ESPNcricinfo coaching glossary)
- Relaxed hands that ride back on impact cushion the pace of the nick, whereas stiff fingers act like a wall and pop the ball out. (Source: Recognised cricket coaching material)
- A nick off a quick bowler comes through hard and flat, so first slip drops back to let it carry, while a spinner's edge is slower and calls for a closer, finer position. (Source: ESPNcricinfo coaching glossary)
- Most edges travel below waist height, so a fielder already rising has to drop back down again, losing the split second a sharp catch needs. (Source: Recognised cricket coaching material)
- Statistically the thickest cluster of catchable edges goes to second slip, so the safest catcher tends to be stationed there rather than at first. (Source: ESPNcricinfo)
- With thumbs together and fingers down, the hands form a cup under a ball dipping towards the boots, which is the shape most slip chances need. (Source: Recognised cricket coaching material)
- Square of the wicket, the gully is closer to the bat's arc and the edge is a flat cut or push, so there is less time to sight and move to it. (Source: ESPNcricinfo coaching glossary)
- A bat-pad catch flies off at an unpredictable angle and dies quickly, so the fielder stays balanced and loaded to dive left or right instantly. (Source: Recognised cricket coaching material)
- Reaching or grabbing early tightens the hands too soon; letting the ball travel into soft, relaxed fingers is what completes the catch. (Source: ESPNcricinfo)
- A ball sliding down leg can tickle the glove or the inside edge and run through fine, and the leg slip stands just behind square to snap that chance up. (Source: ESPNcricinfo coaching glossary)

## Test 3: The outfield, the chase and the throw

- Curving onto the ball so the throwing side is trailing lets the fielder pick up and release in one motion without breaking stride. (Source: ESPNcricinfo coaching glossary)
- A little skip-and-plant transfers the run-up's momentum into the throw, adding distance and pace without a big loss of accuracy. (Source: Recognised cricket coaching material)
- A flat throw arrives quickest for a direct hit or a clean take over the stumps, but it is only worth the risk when the run-out chance is real. (Source: ESPNcricinfo)
- A single well-judged bounce keeps a very long throw on target and lets the keeper take it cleanly at glove height rather than reaching or diving. (Source: Recognised cricket coaching material)
- If the throw beats the stumps and no one is behind, the batters run again, so a backer-up sprints into line to cut off the extra runs. (Source: ESPNcricinfo coaching glossary)
- Sliding lets a sprinting fielder get a hand or a boot to the ball at full stretch and drag or flick it back before it crosses for four. (Source: Recognised cricket coaching material)
- Parrying or tossing the ball infield before touching the rope, then returning to complete the catch, is the legal way to save a six on the boundary. (Source: ESPNcricinfo coaching glossary)
- Timing a few steps in with the delivery means the fielder is already moving towards the ball, not flat-footed, when it comes off the bat. (Source: Recognised cricket coaching material)
- A visible, accurate arm in the deep deters batters from chancing a second or a sharp single into that region for the rest of the innings. (Source: ESPNcricinfo)
- A long barrier with the body behind the hands makes sure a misfield does not cost four, and holding the batters to two is the deep fielder's basic job. (Source: Recognised cricket coaching material)

## Test 4: Wicket-keeping

- Up at the stumps the keeper can stump a batter who overbalances or misses, which is worth the harder take against spin and slow-medium, but not against genuine pace. (Source: ESPNcricinfo coaching glossary)
- From a deeper position the keeper lets a quick bowler's delivery come down from its peak into the gloves at a comfortable height, with more time to move to any edge. (Source: Recognised cricket coaching material)
- A big-turning leg break that starts at leg stump and spins away past off forces the keeper to move late and take it wide, often one-handed, outside the off stump. (Source: ESPNcricinfo)
- The batter's back and legs hide the ball for a moment, so the keeper has to anticipate the line, step round quickly and take it almost blind. (Source: Recognised cricket coaching material)
- With the keeper up, a batter who tries to charge a slower ball risks being stumped, so it pins him in the crease and cuts off the advance down the pitch. (Source: ESPNcricinfo)
- Riding the hands back with the pace of the ball absorbs the sting and keeps the ball in the gloves, exactly as a slip fielder uses soft hands. (Source: Recognised cricket coaching material)
- A delivery gripping broken ground can bounce steeply or scuttle through, so the keeper stays low and lets the ball come rather than committing early. (Source: ESPNcricinfo)
- If the batter's foot is over the popping crease and off the ground when the keeper gathers, the bails come off and the batter is out stumped. (Source: ESPNcricinfo coaching glossary)
- Taking a position a fraction outside off gives the keeper an unobstructed view of the ball all the way, and he steps back across for anything down leg. (Source: Recognised cricket coaching material)
- Behind the stumps he sees the pitch and the batter best, so he calls fielding adjustments, and he sprints to back up throws at the bowler's end every ball. (Source: ESPNcricinfo)

## Test 5: Run-outs and pressure fielding

- From close range with a clear sight of the stumps, a direct hit removes the extra second a relay throw costs, and that second is often the whole margin. (Source: ESPNcricinfo coaching glossary)
- The run-out is likeliest where the batter has furthest still to travel, so the throw goes to the end the trailing or slower runner is heading for. (Source: Recognised cricket coaching material)
- Snatching at the stumps before the ball is secure risks fumbling both, so the safe method is a clean catch and then a controlled hand or ball onto the bails. (Source: ESPNcricinfo coaching glossary)
- If the throw beats everyone, the ball runs away and the batters take another run or two, so someone sprints into line behind the target end every time. (Source: Recognised cricket coaching material)
- A fielder in front of the wicket square of the pitch has an unobstructed throw to the bowler's end, whereas the striker's end is often screened by the batter. (Source: ESPNcricinfo)
- Moving in hard to meet the ball takes metres and a fraction of a second off the return, which is the difference between a run saved and a run-out made. (Source: Recognised cricket coaching material)
- Squeezing the circle in turns a routine push-and-run into a coin-flip, and the batting side either takes the risk or lets the required rate climb. (Source: ESPNcricinfo)
- Deliberately deceiving the batters with a sham throw or gather is fake fielding, and the umpires award the batting side five penalty runs. (Source: ESPNcricinfo)
- With both batters stranded together, breaking the wicket at the vacant end runs out whichever batter has not made good his ground there, so there is no need to rush wildly. (Source: Recognised cricket coaching material)
- A fielder posted deeper square lets the batter push a single but denies the comfortable two, so the score moves along in ones rather than twos and fours. (Source: ESPNcricinfo)

Sources: ESPNcricinfo and its coaching glossary for technique and tactics; recognised cricket coaching material for stroke play, bowling actions and field settings; general cricket knowledge for match situations. Level 3 is skills and judgement, not the Laws, so the MCC code is cited only where a Law underpins a tactical point. Questions are authored from these sources, not reproduced from them.

Take the tests: https://insporta.app/try?utm_source=book&utm_medium=referral